GOOD2GRO SUPER STRONG GRO & REPAIR SYSTEM INSTRUCTION FOR USE

Shampooing:

The first step in using the Good2Gro system is clean the hair and scalp by shampooing with Good2Gro Super Strong Gro & Repair Sulfate-Free Shampoo. Gently detangle your hair with a wide tooth comb. Starting from the ends, working up to the roots. Saturate your hair with water before applying the shampoo.

 

Take a quarter-sized amount of shampoo and work it into lather. Repeat. Concentrate on massaging your scalp. Remember, shampooing is for cleaning the hair and the scalp.

Massage your scalp deeply to stimulate the follicles and loosen any flakes that may be there.

 

Rinse your hair until all traces of shampoo are gone. This should take about 1 ½ to 2 minutes. Part your hair and check to make sure it’s all out. If not, rinse again.

 

Gently squeeze the water out of your hair.

Conditioning:

The next step in using the Good2Gro System is using the Good2Gro Super Strong Gro & Repair “Tingling” Conditioner. Shampooing got your hair clean but the conditioner is what makes the scalp healthy and leaves the hair healthy looking.

 

Never skip the conditioning process after shampooing your hair. Moisture needs to be put back after the natural oils that are removed with shampooing. The Good2Gro “Tingling” Conditioner replenishes the needed moisture and effectively conditions the hair.

 

Apply a generous amount of conditioner from roots to ends. Concentrate on the last ¼ of the length since this is the oldest part of your hair. Insure to get conditioner on your scalp, especially if you have issues with dandruff and dry scalp.

 

Let conditioner sit 10-15 according to the instructions or use a plastic cap and heat for a deep penetrating treatment.

 

Rinse the conditioner out, but don’t over rinse. You want to leave a slight coating of conditioner in your hair for moisture retention.

 

Gently squeeze and blot the water from your hair. Never rub with a towel because that causes breakage and damage.

Leave-N Treatment:

The next step is to seal in the conditioner. The Good2Gro Leave-N Treatment seals in the moisture. After you’ve hydrated your hair by washing and conditioning properly you should use The Good2Gro Leave-N Treatment. Saturate the hair completely. The Good2Gro Leave-N Treatment is infused with emollients that benefits the hair in several ways.

 

  • Controls frizzy and flyaway hair.
  • Detangles and moisturizes.
  • Leaves hair feeling soft and manageable.
  • Acts as a heat barrier to direct and indirect hair drying and styling techniques.

 

Serum:

On damp or dry hair, apply a dime size of Good2Gro Super Strong Gro & Repair Serum to hair and scalp, concentrating on balding and thinning area. Massage into scalp. Do not rinse out. For an extra moisture treatment and to seal split-ends massage Serum in from root to tip. Maybe used as a hot oil treatment.

 

(Note) If you have very fine hair that gets weighed down easily, reduce the amount of Serum on the hair and concentrate on invigorating the scalp. (Note) Do not use the Serum and the Resuscitator at the same time, this may result in blocking the hair follicles and slowing the new growth process. Use these products sparingly.

Resuscitator:

Part hair and massage a small amount of Good2Gro Resuscitator into the hair and scalp. Gently distribute from roots to ends, giving special attention to damaged, balding and thinning areas on the scalp. Brush hair gently often to stimulate blood flow and style.

 

(Note) Do not use the Serum and the Resuscitator at the same time, this may result in blocking the hair follicles and slowing the new growth process. Use these products sparingly.

Edge & Curl Paste:

This superior sculpting and control pomade is used to creates sculpted curls and to smooth down unruly edges. Locks in styles, moisture and shine without leaving hair Flaky, tacky, hard or crunchy.